Performance Specifications

 

Shop-Vac® UltraPro Series Wet/Dry Vacuums

 
Performance Specifications
Peak Horsepower 4 5 5.5 6.25 6.5
Cubic Feet Per Minute
(CFM) of Air Flow
180 190 195 205 210
Sealed Pressure
(in inches)
57 59 59 60 60
Electrical Ratings 120V
60Hz
10.5A
120V
60Hz
11A
120V
60Hz
11.5A
120V
60Hz
11.9A
120V
60Hz
12A
Peak Air Watts 330 340 345 370 390

Terminology:

Horsepower Rating
"Peak Horsepower" (PHP) is a term used in the wet-dry vacuum industry for consumer comparison purposes. It does not denote the operational horsepower of a wet-dry vacuum but rather the horsepower output of a motor, including the motor's inertial contribution, achieved in laboratory testing. In actual use, Shop-Vac® motors do not operate at the peak horsepower shown.

Tank Capacity
Tank capacity refers to actual tank volume, and does not reflect capacity available during operation.

SP (Sealed Pressure)
Suction pressure represents how far up a glass tube a vacuum motor will lift a column of water. This function is measured in inches. Maximum suction pressure or sealed water lift is obtained at zero air flow. Suction pressure decreases as air flow increases.

CFM (Cubic Feet Per Minute)
CFM is a measure of the quantity of air moved by the vacuum motor at a particular system load, such as 2-1/2" orifice. Your actual system load is determined by the type, size and length of the hose used, the accessory tool used and the filter system used. A dirty filter system can drastically affect the suction and air flow. The filters need to be cleaned regularly and replaced as necessary to avoid reduced suction and air flow.

Vacuum Performance
Vacuum performance or air power is the rate of work performed by a vacuum cleaner. Air power is a function of suction and air flow at an operating point. Air power is reduced by dirty filters, leaks and attachments used.

Specifications subject to change without notice.

 
 
     

Go Back GO BACK